15
2. Press
until the start time appears that you want to delete.
3. Press until the word OFF appears.
Press the button to proceed to the next step RUN TIME or to review
the program.
12. SETTING WATERING RUN TIMES (PROGRAM(S) DURATION)
This setting determines the length of time the 400A Series controller will allow the
valve to remain open (duration is from 1 minute up to 5 hours and 59 minutes).
For example, setting watering run time to 10 minutes on certain days of the week
will program the controller to turn the water on for 10 minutes on each of the days
chosen and at every start time selected. (Note: if the controller is set to water every
X hours, the maximum duration is 59 minutes)
To set the watering run time :
1. Press the button until the
icon appears and OFF or the last run time
setting appears. (OFF will appear if duration is set to 0)
2. Press the button, and 0:00 (or the last run time programmed) appears with
hours flashing.
3. To set a desired watering run time in hours, press or and select the
number of hours.
To Next Page
Loading...
Need help?
General
