TO ORDER REPLACEMENT OR SPARE PARTS:
1-800-344-2281 FAX: 760-727-0282
We at DIG Corporation understand that most dealers do not carry spare parts. For your convenience, if you need
one of these parts. SEND your order to DIG Corporation, 1210 Activity Drive, Vista, CA 92083.
Parts will be sent within 5 days.
For faster service, you may call DIG’s customer service number
1-800-322-9146 and parts can be shipped immediately.
All non pre-paid phone orders over $20 will have an added COD charge.
Make checks payable to Dig Corporation.
Choose correct part and circle.
Add total dollar value $__________
Add $5.00 for shipping and handling $___5.00__
__
California residents add sales tax $__________
TOTAL $__________
11
Controller with Solenoid
$35.00
Controller Sleeve Body
$2.80
3/4" Plastic Valve
$8.00
3/4" Female Swivel
Adapter, FHT x MPT
$1.10
Bottom Sleeve
$1.20
Male Adapter
3/4" MHT x 3/4" MPT
$0.80
Bolts
$0.15
Cover for 3/4" Valve
$5.00
Springs for 3/4" Valve
$0.45
Diaphragm for 3/4" Valve
$4.00
Body for 3/4" Valve
$8.00
10
Suspension:
Press for 3 consecutive seconds until the appears.
Cancel Suspension:
Press for 3 consecutive seconds to return irrigation system control to
the irrigation controller. The symbol will disappear.
■ During suspension, the button will not function.
5. ADDITIONAL DISPLAYS
5.1 BLINKING LOW BATTERY WARNING
A blinking battery icon appears on the display when the
batteries are weak. At this point, the battery still contains a
limited amount of energy for valve operation. The battery
should be replaced promptly.
If the battery is not replaced, the irrigation controller will
continue to open the valve 8 additional times according to
the program. It will then suspend the program and OFF will appear on the screen.
Program data will be retained for 30 seconds during battery changing.
An irrigation controller without a battery will not operate the valve.
5.2 MISSING DEFINITION IN IRRIGATION PROGRAM
noPr will appear when programming irrigation days (see
section 4.3
‘Programming Irrigation Days’), if no irrigation
days have been specified.
In this case, the valve cannot be opened during the
computerized manual operation (see section 4.5).
5.3 PROGRAMMING ERROR
In the cyclical program (see section 4.4) if the irrigation
duration programmed is equal to or longer than the
irrigation cycle, the word Err will appear.
To cancel the error, press or to increase the
irrigation cycle.
6. MAINTENANCE
1. Remove batteries if the irrigation controller will not be used for a prolonged period.
2. Under normal usage, the battery (alkaline) should last for at least one year.
3. Recommended water pressure – 10-135 psi.
4. Remove timer when temperature drops below 32°F.
7. HELPFUL HINTS AND ADDITIONAL INFORMATION
1. Keep cover closed after programming.
2. Test valve in manual mode after programming.
3. Minimum flow rate is 30 gph.
To Previous Page
Loading...
Need help?
General
