9.5 SETTING WATERING RUN TIMES:
This setting determines the length of time each valve on the 720A, 740A and 760A
controllers will remain open to allow watering during operation.
For example, setting a run time of 10 minutes on valve 1 will allow the controller
to run valve 1 for 10 minutes on each start time during each day the program is
active. Depending on which model obtained, up to 2, 4, or 6 valves will be available
to set for each program.
9.5.1 TO SET WATERING RUN TIMES:
1. Press or until you see shown on the bottom of the display.
2. Press to modify this setting.
NOTE: By default, the run time of valve 1 on program A is set to 5 minutes
(0:05) and programs B through D are set to OFF. The valve currently being
looked at viewed is underlined on the display near the icon centered
below the run time.
3. Press or to set the hours.
4. Press and then or to set the minutes.
5. Press to confirm your settings.
9.5.2 TO SET RUN TIMES FOR THE REST OF THE VALVES:
9.5.2.1 OPTION 1 – SCROLLING THROUGH EACH VALVE:
1. Press
to modify this setting.
2. Press or consecutively until the number
of the valve to be changed
is underlined.
3. Use or to set the hours and minutes.
18
To Next Page
Loading...
Need help?
General
