20
16. MAINTENANCE, TROUBLESHOOTING AND REPAIRS
To restore the timer to the default settings
1. Press the
button until the START EVERY is displayed and the icon
appears on the bottom left of the screen.
2. Press and hold down the
for three seconds.
3. The screen returns to the home screen (clock) and all the default settings are
restored. The current time and date is retained.
PROBLEM: Timer fails to open automatically or manually
CAUSE: No water pressure
SOLUTION: Open main water supply valve
CAUSE: Flow control knob is turned down
SOLUTION: Turn flow control knob clockwise to open
PROBLEM: Valve/actuator functions via the manual mode but
not automatically
CAUSE: Timer is set to OFF mode
SOLUTION: Verify that the timer does not show OFF in current time mode
CAUSE: AM/PM not set correctly in current time mode
SOLUTION: Check current time, change AM/PM if necessary
CAUSE: AM/PM not set correctly in start time mode
SOLUTION: Check start time(s), change AM/PM if necessary
CAUSE: Rain delay is preventing watering
SOLUTION: Set rain delay to off
CAUSE: Yellow sensor wires have been cut
SOLUTION: Re-connect sensor wires together with waterproof connector
CAUSE: Sensor is installed and is in a state that prevents watering
SOLUTION: Check sensor and wire splices and verify sensor is normally closed
To Next Page
Loading...
Need help?
General
