HI, MI, WI-700 service manual
Issue 9 04/2020
Take-up motor 2-50
Label gap sensor 2-51
Power ON/OFF switch 2-52
Thermal head pressure (Signature) 2-52
Touch applicator - (Signature) 2-53
Blow bar 2-54
Pneumatic connections 2-55
Multijet air box - (Signature) 2-56
HS blow applicator 2-57
Base labeller belt applicator 2-60
Touch applicator - classic labeller 2-61
3 - Routine Maintenance
Removal and cleaning of conveyor belts 3-2
Removal of base labeller outfeed conveyor 3-4
Pack sensors 3-5
Cleaning the thermal head 3-6
Cleaning labeller drive and pinch rollers 3-8
Condition of wear strip (Signature labeller) 3-9
Condition of platen roller (Classic labeller) 3-9
Cleaning the control box and display 3-10
4 - Servicing
Conveyors
Drive belt 4-3
Base labeller outfeed conveyor belt removal 4-4
Conveyor roller replacement - click-in type conveyor 4-5
Drive belt pulleys - metal bearings 4-6
Drive belt pulleys - plastic bushes 4-7
Motor drive belt, drive shaft & bearing, Evo type (infeed/outfeed) 4-8
Motor drive belt, drive shaft & bearing, non Evo type (infeed/outfeed) 4-10
Motor drive belt, drive shaft & bearing, Evo & non Evo (scale) 4-12
Conveyor speed checking 4-15
Weighing
Load cell 4-16
Load cell overload stops 4-18
Re-calibration of machine - Console software 4-19
Re-calibration of machine - Worldview software 4-21
Electrical cabinet
A/D unit 4-23
Hard drive 4-27
Pack sensor adjustment - fibre optic 4-29
Pack sensor adjustment - opto electric (Wenglor) 4-31
Touch screen
LED screen & touch panel - 12.1'' 4-32
Calibration of touch panel - 12.1'' 4-36
LED screen & touch panel - 15'' 4-37
Calibration of touch panel - 15'' 4-40
Signature labeller servicing 4-41
Removal of thermal head 4-42
Replacement of wear strip 4-44
Replacement of Platen roller 4-46
Thermal head pressure 4-47
Thermal head horizontal position 4-48
Thermal head horizontal position - fine adjustment 4-52
Thermal head vertical position 4-53
To Next Page
Loading...
Need help?
General
