HI, MI, WI-700 service manual - 2 - component parts
2-48 Issue 9 04/2020
Power supply 42v (LS200-48)
This PSU supplies 42v to the stepper motor.
The input voltage to this power supply is 100-240vAC and this
voltage is obtained from the labeller mains terminal
connection inside the main electrical cabinet.
The output is:
Voltage = 42v +/- 0.3v
Power - output wattage = 200w
Rated current = 4.2A
NOTE: The standard manufactures output voltage for this
power supply is 48V.
The power supply is reset to 42V for this labeller
application therefore the adjustment trimmer should not
be adjusted. This is pre-set to the correct output voltage
for the labeller
To PL11 on labeller
board
+42v to pins 9 & 10
0v to pins 7 & 8
Mains power from
electrical cabinet
LS200-48
Power supply
Set power supply output voltage
to 42v
To Next Page
Loading...
