Digi WI-700 - Page 6

HI, MI, WI-700 service manual
Issue 9 04/2020
6 - Maintenance schedule
Maintenance schedule introduction 6-2
All conveyors 6-3
Scale 6-4
Labeller 6-5
Label applicators 6-6
Side & HS blow label applicators 6-7
Base label applicator 6-8
Labeller lifting gear 6-9
Touch screen 6-9
Air regulator 6-9
Pack sensors 6-9
Safety 6-10
Machine stability 6-10
Inside electrical cabinet 6-10
Outside electrical cabinet 6-11
7 - Fault finding
Operational problems 7-2
On screen error messages - Console software 7-3
On screen error messages - Worldview software 7-4
Labeller problems 7-5
Labeller error codes (lab sw V:40013 &below) 7-6
Labeller error codes - (lab sw V:50019 & above) 7-8
Conveyors 7-10
Pack sensors 7-11
Scale not working 7-12
Fault finding checks on A/D board 7-12
Labeller board LED’s 7-13
How to PING the labeller to check communication 7-14
Sleever interface operation error codes 7-16
8 - Recommended spare parts
Electrical cabinet 8-2
Screen assembly 8-2
Pack sensors 8-2
Scale 8-2
Conveyor belts - HI-700 8-3
Conveyor belts - HI-700W 8-4
Conveyor parts - HI / HI-W 8-5
Conveyor - MI-700 8-6
Conveyor - WI-700 8-7
Labeller—Signature type 8-8
Labeller—Classic type 8-8
9 finger touch applicator—for Signature labeller 8-9
Belt applicator for base labeller 8-9
Air box applicator—for Signature labeller 8-9
9 finger touch applicator—for Classic labeller 8-9
Side applicator - for Signature labeller 8-9
HS blow applicator 8-9
Air regulator 8-9