AT commands Cellular commands
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
106
Default
N/A
MV (Modem Firmware Version)
Read the firmware version string for cellular component communications. See the related VR
(Firmware Version) command.
Parameter range
N/A
Default
Set in the currently loaded firmware
DB (Cellular Signal Strength)
Reads the absolute value of the current signal strength to the cell tower in dB. If DB is blank, the XBee
Smart Modem has not received a signal strength from the cellular component.
Parameter range
0x71 - 0x33 (-113 dBm to -51 dBm) [read-only]
Default
N/A
AN (Access Point Name)
Specifies the packet data network that the modem uses for Internet connectivity. This information is
provided by your cellular network operator. After you set this value, applying changes with AC (Apply
Changes) or CN (Exit Command mode) triggers a network reset.
See Network connection issues if the XBee Smart Modem is not joining the network.
Parameter range
1 - 100 ASCII characters
Default
-
CP (Carrier Profile)
Configures the cellular component to select network operator settings (RF bands, packet data
configuration) for various networks.
The default setting of 0 (autodetect) increases the boot time.
Changes to the value only take effect on boot so a reboot or power cycle is required for any changes
to become active.
Parameter range
0 - 3
To Next Page
Loading...
