AT commands Diagnostic interface commands
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
131
CK (Configuration CRC)
Displays the cyclic redundancy check (CRC) of the current AT command configuration settings.
Parameter range
0 - 0xFFFFFFFF
Default
N/A
Diagnostic interface commands
The following AT commands are diagnostic interface commands.
DI (Remote Manager Indicator)
Displays the current Remote Manager status for the XBee.
Range
Value Description
0x00
Connected
0x01
Before connection to the Internet
0x02
Remote Manager connection in progress
0x03
Disconnecting from Remote Manager
0x04
Not configured for Remote Manager
Default
N/A
CI (Protocol/Connection Indication)
Displays information regarding the last IP connection when using Transparent mode (AP = 0).
The following table provides the parameter's meaning when IP = 0 for UDP connections.
Parameter Description
0x00 The socket is open.
0x01 Tried to send but could not.
0x02 Invalid parameters (bad IP/host).
0x03 TCP not supported on this cellular component.
0x10 Not registered to the cell network.
To Next Page
Loading...
