Digi XBee3 - HV (Hardware Version); AI (Association Indication); HS (Hardware Series)

AT commands Firmware version/information commands
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
130
HV (Hardware Version)
Read the device's hardware version. Use this command to distinguish between different hardware
platforms. The upper byte returns a value that is unique to each device type. The lower byte indicates
the hardware revision.
Parameter range
0 - 0xFFFF [read-only]
Default
Set in firmware
AI (Association Indication)
Reads the Association status code to monitor association progress. The following table provides the
status codes and their meanings.
Statuscode Meaning
0x00 Connected to the Internet.
0x22 Registering to cellular network.
0x23 Connecting to the Internet.
0x24 The cellular component is missing, corrupt, or otherwise in error. The cellular
component requires a new firmware image.
0x25 Cellular network registration denied.
0x2A Airplane mode.
0x2B USB Direct active.
0x2C Cellular component is in PSM.
0x2F Bypass mode active.
0xFF Initializing.
Parameter range
0 - 0xFF [read-only]
Default
N/A
HS (Hardware Series)
Read the device's hardware series number.
Parameter range
N/A
Default
Set in the firmware