AT commands Addressing commands
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
110
Bit 0 - Remote Manager support
If the XBee Smart Modem cannot establish a connection with Remote Manager, it waits 30 seconds
before trying again. On each successive connection failure, the wait time doubles (60 seconds, 120,
240, and so on) up to a maximum of 1 hour. This time resets to 30 seconds once the connection to
Remote Manager succeeds or if the device is reset.
Bit 2 - USB direct enable
Set bit 2 to enable USB direct mode. After setting, use WR (Write) to write all values to flash and use
FR (Force Reset) to reset the device.
Note Setting P0 (DIO10/PWM0 Configuration) to 6 overrides setting DO bit 2.
Bit 3 - PSM
To enable PSM, set DO (Device Options) bit 3. See Power Saving Mode (PSM) for details.
Range
0x00 - 0x0F
Bitfield
Bit Description
0x01 Enable Remote Manager
0x04 Enable USB Direct
0x08 Enable PSM
Note We strongly recommend that you clearbit 0 (Enable Remote Manager) if you set bit 3. If not, the
connection that the device retains with Remote Manager causes the cellular component to spend very
little time in low power, negating the value of selecting that feature.
Default
0x01
EQ (Remote Manager FQDN)
Sets or display the fully qualified domain name of the Remote Manager server.
Range
From 0 through 63 ASCII characters.
Default
my.devicecloud.com
Addressing commands
The following AT commands are addressing commands.
To Next Page
Loading...
