Digi XBee3 - Tx Request with TLS Profile - 0 X23

API frames Tx Request with TLS Profile - 0x23
Digi XBee3 Cellular LTE-M Global Smart Modem User Guide
147
Tx Request with TLS Profile - 0x23
Description
This frame uses the serial data service. The frame gives greater control to the application over the IP
setting for the data.
A TX Request message causes the device to transmit data in IPv4 format. A TX request frame for a
new destination creates a network socket. After the network socket is established, data from the
network that is received on the socket is sent out the device's serial port in the form of a Receive (RX)
Packet frame.
Format
The following table provides the contents of the frame. For details on frame structure, see API frame
format.
Field name
Field
value Data type Description
Frame type 0x23 Byte
Frame ID Byte Reference identifier used to match status responses. 0
disables the TX Status frame.
Destination
address
32-bit big
endian
Destination port 16-bit
bigendian
Source port
16-bit
bigendian
If the source port is 0, the device attempts to send the frame
data using an existing open socket with a destination that
matches the destination address and destination port fields
of this frame. If there is no matching socket, then the device
attempts to open a new socket.
If the source port is non-zero, the device attempts to send
the frame data using an existing open socket with a source
and destination that matches the source port, destination
address, and destination port fields of this frame. If there is
no matching socket, the TX Status frame returns an error.
TLS profile Byte Zero-indexed number that indicates the profile as specified
by the corresponding $<num> command.