What to do if there is occlusion in the IV tubing of DigiCare Pet Care Product?
If there is an occlusion in the IV tubing of your DigiCare Pet Care Product, check if the IV tubing is folded. Also, verify that the roller clamp is open and the needle is not blocked. If the IV set is too hard or large, consider replacing it or lowering the occlusion sensitivity.
Why are no drops detected in my DigiCare Pet Care Product?
If no drops are detected by your DigiCare Pet Care Product, first, check if the solution container is empty. Second, examine the drop chamber for excessive fog drops or if the chamber is too tilted, causing the liquid to flow along the sidewall instead of dripping.
How to remove air from the tube in DigiCare DigiPump LP8?
To remove air from the tube of your DigiCare Pet Care Product: 1. Open the pump door; the tube clamp will grip the tube automatically. 2. Remove the tubing above the tube clamp. 3. Tap the tubing to expel the air back to the drop chamber. 4. Reinstall the tubing and close the pump door to continue the infusion.
What to do if the pump door is open on DigiCare Pet Care Product?
If the pump door of your DigiCare Pet Care Product is open, make sure to close and lock it properly.
What to do if the battery voltage is low on DigiCare DigiPump LP8?
If the battery voltage of your DigiCare Pet Care Product is low, promptly connect it to AC power or replace the battery with the same type.
How to clear alarm on DigiCare DigiPump LP8 Pet Care Product?
To clear the alarm on your DigiCare Pet Care Product, press the designated button.
Why is my DigiCare Pet Care Product leaking?
If you notice leakage with your DigiCare Pet Care Product: 1. Check whether the IV set is mounted correctly. 2. Check whether the drop detector is violently disturbed or shaken.
Why DigiCare Pet Care Product can’t turn on?
If your DigiCare Pet Care Product doesn't turn on when you press the power button: * Reinstall the battery properly. * Connect to AC power and turn the rear panel switch on.
What to do if the battery failed on DigiCare DigiPump LP8?
If the battery has failed in your DigiCare Pet Care Product, check the battery connection or replace it with the same type of battery.
What to do if the drop detector is disconnected from DigiCare DigiPump LP8?
If the drop detector is disconnected from your DigiCare Pet Care Product: 1. Check and ensure the drop detector is connected and mounted properly. 2. Check whether the connector is broken.
General| Brand | DigiCare |
|---|---|
| Model | DigiPump LP8 |
| Category | Pet Care Product |
| Language | English |
To Next Page