Why does DigiCare Pet Care Product flash even with IV set installed?
If the IV set is installed and there is no air in the tube, but the alarm still flashes on your DigiCare Pet Care Product: 1. Press the clear alarm button. 2. Mount the IV set correctly. 3. Ensure no distortion occurs.
What causes abnormal infusion in DigiCare DigiPump LP8?
If there is abnormal infusion with your DigiCare Pet Care Product: 1. Check whether the drop detector is connected and mounted properly. 2. Check whether there are too many fog drops in the drip chamber or the liquid level of the chamber is too high. 3. Check whether the air inlet of the solution container is blocked.
What to do when infusion finished on DigiCare Pet Care Product?
Once the infusion is finished with your DigiCare Pet Care Product: 1. Change to a new solution container and set the parameters again. 2. Remove the IV set.
What happens if the DigiCare DigiPump LP8 Pet Care Product is paused for over 2 minutes?
If the pause time exceeds 2 minutes on your DigiCare Pet Care Product: 1. Press the clear warning button, but the pause is maintained. 2. Press the restart infusion button to restart the infusion.
Why is pump cassette not running on DigiCare DigiPump LP8 Pet Care Product?
The pump cassette may not be running because the IV set is defective or installed improperly, causing the pump to be blocked. Alternatively, the pump cassette may not run due to residues and dirt.
General| Brand | DigiCare |
|---|---|
| Model | DigiPump LP8 |
| Category | Pet Care Product |
| Language | English |
To Next Page