Chapter 3: Remote Operation 29
2 Press and hold SHIFT while pressing multiple
SELECT buttons (to group multiple channels).
3 Press and hold OPTION+SHIFT while rotating
an encoder in the group, until the desired gain
level is displayed.
To exit Global mode:
1 Press F3 again.
Individual Channel Mode
This mode dedicates the ProControl’s DSP
Edit/Assign section on the main unit for control
of all parameters of a single PRE channel in Pro
Tools. Multiple preamps can be adjusted if the
tracks have lit SELECT buttons in conjunction
with SHIFT and OPTION held while moving pa-
rameters.
The F2 switch, located at the top left of the Fader
section, toggles between control of Mic Preamp
channels and insert focus for the main unit's
DSP Edit/Assign section.
When Individual Channel mode is active, the
F2 LED flashes, and the DSP Edit/Assign section
displays the current Mic Preamp status on its
eight rows of LEDs, as follows:
• If the channel with focus has a Mic
Preamp, the DSP Edit/Assign LED display
updates with PRE parameter names and
values (see the table, below).
• If the channel with focus does not a have a
Mic Preamp, the LED display updates with
the following message: “No Mic Pre As-
signed To This Channel.”
• If no channel is focused, the first channel
in the currently viewed bank of faders is au-
tomatically given focus, and the DSP
Edit/Assign section display updates with
PRE parameter names and values (see the
table, below).
Mic Preamp Parameters in the DSP Edit/Assign
Section
The Mic Preamp name is displayed in the
CHANNEL/GROUP display of the DSP
Edit/Assign section; the default Mic Preamp
name is PRE #1. Channel parameters and values
are displayed in the DSP Edit/Assign LED
displays, as follows:
In older Pro Tools versions, the F2 F-Key
switch was used to display which Pro Tools
channel strips had active plug-ins assigned
to them. With Pro Tools TDM 5.3.1 and
higher, this operation is now accomplished
by pressing OPT(ALT)ALL+F2.
Channel focus is determined by a lit
INS/SEND button on a track.
PRE Parameters in the DSP Edit/Assign LED Displays
Scribble
Strip
Parameter Names and
Values (in DSP Edit/Assign
LED Displays)
DSP
Edit/Assign
Control
1 MGn (Mic Gain),
LGn (Line Gain),
or
IGn (Inst Gain)
0–69 Encoder
2 Src Mic,
Line,
or DI
Encoder
3 Ø (Phase Invert) On/Off IN/OUT
4 48v On/Off IN/OUT
5 HPF In/Out IN/OUT
6 Ins (Insert) In/Out IN/OUT
7 –18 In/Out IN/OUT
8 Imp
(Input
Impedance)
1.5K,
15K,
or
1.5M
Encoder
To Next Page
Loading...
Need help?
General