DR5000 DIGICENTRAL
P 29
www.digikeijs.com
5.3 Connecng iTrain through USB
Start iTrain and in the changes menu click on interface. In the interface eld choose S LocoNet©.
Open the serial tab and choose 115200 as the baud rate and the right LocoNet COM port, as explained on page 20. In the example below we’ve used COM7.
Click OK and try to connect to the DR5000 by clicking on ‘connect’. In the boom right in iTrain you can see whether this has succeeded and if iTrain is now
‘online’. Check whether the controller responds to the stop and start buon. If so, the connecon has been successful!
To Next Page
Loading...