Digital Projection E-Vision Laser 8500 Series User Manual

page 68
Digital Projection E-Vision Laser 7500 & 8500 Series
Operating Guide
USING THE PROJECTOR
Rev B September 2016
Setup menu continued from previous page
OSD Settings
• Language sets the OSD language.
• Menu Position determines where the OSD should appear ont he screen when
activated.
• Menu Transparency sets OSD transparency between 0% (no transparency), 25%,
50% and 75%.
• Time Out determines how long the OSD should remain on screen if no buttons are
pressed. Choose Always On to disable this feature.
• Message Box determines whether projector status messages should appear on the
screen.
Memory
The current image settings can be saved as a preset, which you can recall later. The
default settings can be recalled at any time as well.
Up to four custom presets can be stored for each input.
The following settings are saved in a preset:
• From the Image menu — Gamma, Brightness, Contrast, Saturation, Hue,
Sharpness and Noise Reduction
• From the Color menu — Color Space, Color Mode, ColorMax,
Color Temperature, Dynamic Black, RGB Lift and RGB Gain
• From the Geometry menu — Aspect Ratio and Overscan
To recall a saved preset:
• Select Recall Memory and press ENTER/OK, then select a preset from Preset A to
Preset D. Select Default to load factory default values.
To save a preset:
• Select Save Settings and press ENTER/OK, then choose from Preset A, Preset B,
Preset C and Preset D.
Notes
Presets from one input cannot be
applied to another input.
OSD Settings
Menu Position
Menu Transparency
Language
Time Out
Message Box
Center
0
English
30 Seconds
On
Memory
Save Settings
Recall Memory
Preset A
Default

Digital Projection E-Vision Laser 8500 Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 8500 Series
Category	Projector
Language	English