30
found in the <REVERB> library, and their Parameters are as follows:
Gated Reverb On / Off..Turns the Module on or off.
Reverb Pre-Delay..........Sets the amount of time before the reverbera-
tions are heard. Adjustable from 0 to 100 mil-
liseconds.
Rvb Decay Time............Controls the amount of time before the gate
cuts off the reverberations. Variable from 20 to
1000 milliseconds.
Rvb Envelope................Sets the shape of the reverberation envelope
(DECAYING, FLAT, or REVERSE).
Rvb Diffusion.................Controls the smoothness of the reverberations.
Variable from 1 to 10.
Rvb LPF Frequency ......Reverb low-pass filter. Sets the frequency
below which reverberations will be heard.
Adjustable from 25Hz to 18kHz.
Rvb Accent Delay..........Allows placement (in time) of the actual sound,
±50 milliseconds from the reverb gate point.
Rvb Accent Left.............Controls the level of the accent in the left side
of the stereo soundfield. Variable from 0 to
100.
Rvb Accent Right ..........Controls the level of the accent in the right
side of the stereo soundfield. Variable from 0
to100.
Rvb Level Left ...............Sets the output level of reverberations heard in
the left channel. Variable from 0 to100.
Rvb Level Right.............Sets the output level of reverberations heard in
the right channel. Variable from 0 to100.
Section 4 - Effects and Parameters
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
