An auto panner is a modern relative of the tremolo that modulates the sound from left to right at a given rate. Parameters are as follows:
Speed Controls the Panning speed (speed of modulation). Ranges from 0 to 100
Depth Adjusts the intensity of the Panning effect. Ranges from 0 to 100.
A Detuner will make a copy of your incoming signal, and take the copied signal slightly out of tune from the original. This results in a non
modulated Chorus type of effect. Parameters are as follows:
Amount Adjusts the quantity of detuning applied. Ranges from -30 to +30 cents (100 cents = one semi-tone).
The RP14D’s Pitch Shifter will make a copy of your incoming signal, and then shift the pitch of the copy to a different note. As you play one
note the pitch shifter is simultaneously playing a note higher, or lower with you. The RP14D is capable of shifting the signal from 0 to 24
semi-tones (2 octaves) above or below the pitch of the input signal.
Amount Sets the interval between the original note and the pitch shifted note. Variable from -24 to 24 semi-tones.
The RP14D’s pitch bending effect allows you to smoothly bend between two program pitch intervals using the Expression Pedal. As the
Expression Pedal’s Position is modified, the pitch of the original note will change in intervals according to the selection of the Amount. The
Expression Pedal will automatically link to the bend parameter when this effect is selected.
*Note: These Parameters can be assigned to the Expression Pedal. See page 11 for more information on Expression Pedal
assignments.
To Next Page
Loading...
Need help?
General
