20
Programming Song Part Intensities
Each song part can be programmed for normal intensity (PART button is green — this is the default) or high
intensity (PART button is red). Programming the chorus or bridge of your songs with a higher backing band
intensity can help add dynamics, making your songs more exciting. Song part intensity can be selected before or
after teaching the TRIO+ a song part.
To change song part intensity:
1. Press the BAND footswitch to stop band playback.
2. Press the PART button for which you want to change intensity
(the LED which is brightest indicates selection).
3. Press the selected PART button again. The PART button's LED
will change from green to red (programmed for high intensity)
or from red to green (programmed for normal intensity)
depending on its original state.
To Next Page
Loading...
Need help?
General
