To Next PageTo Next PageWhy is the flame not bright or not visible in my Dimplex DF2603?
If the flame in your Dimplex Indoor Fireplace is not bright or not visible, it could be due to burnt light bulbs (replace them). Other potential causes are loose wiring (check wiring connections) or a defective light harness (replace it).
Why does the heater fan run continuously on my Dimplex Indoor Fireplace?
If the heater fan in your Dimplex Indoor Fireplace runs continuously, it could be due to loose wiring (trace wiring in unit). Other potential causes include a defective heater on/off switch (replace it) or a defective heater assembly (replace it).
Why is the flame frozen on my Dimplex DF2603?
If the flame in your Dimplex Indoor Fireplace is frozen, it could be due to a defective flame motor (replace it). Another potential cause is loose wiring (check wiring connections).
What causes excessive noise with the heater on in Dimplex DF2603?
Excessive noise with the heater on in your Dimplex Indoor Fireplace could be caused by a dirty blower assembly (clean blower assembly) or a defective blower assembly (replace heater assembly).
Why is the log set dim and ember bed not glowing in my Dimplex Indoor Fireplace?
If the log set is dim and the ember bed is not glowing in your Dimplex Indoor Fireplace, it's likely due to burnt light bulbs, which will need to be replaced.
What causes grinding noise when heater is off in Dimplex DF2603 Indoor Fireplace?
Grinding or excessive noise with the heater off in your Dimplex Indoor Fireplace could be caused by the moving flame rod hitting or rubbing against internal components (flame rod replacement) or a defective flame motor (replace flame motor).
General| Brand | Dimplex |
|---|---|
| Model | DF2603 |
| Category | Indoor Fireplace |
| Language | English |
Instructions for preparing an existing fireplace for installation.
Steps for preparing a new wall for fireplace installation.
Guidance for installing the fireplace with a mantel surround kit.
How to open the upper grill to access the fireplace controls.
Explanation of the three-position switch for power and mode selection.
Adjusting the flame speed for desired effect.
Adjusting the brightness of the interior lighting.
Turning the heater function on or off.
Setting the desired temperature for the heater.
Information on the integrated remote control for fireplace operation.
Steps to initialize or re-initialize the remote control.
Instructions for replacing bulbs, including requirements for lower and upper bulbs.
Guides for cleaning the glass and exterior surfaces of the fireplace.
Details on what the limited warranty covers and for how long.
Information on products excluded and what the warranty does not cover.
Procedures for obtaining warranty service and how Dimplex handles defects.
What Dimplex and its agents are not responsible for, including liability limitations.
