12
Phillips Head Screwdriver
If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top panel
to cool off to avoid accidental burning of skin.
Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
Slide fireplace out from mantel.1.
Lay replace on its back.2.
Remove the 10 Philips screws that attach the bottom 3.
panel to the replace as shown in Figure 9. There are:
two (2) screws along the bottom edge of each side; two
(2) screws immediately behind the front trim piece, on
each side; and two (2) screws along the back, bottom
edge of the replace.
!
Use caution when removing bottom panel as
there are components attached to the panel which are hard
wired within the replace chassis.
!
The bi-fold doors are supported by the
bottom panel. When pulling the bottom panel away from
the chassis, do so carefully so that the doors do not get
damaged.
Carefully remove bottom panel from replace and swivel 4.
it outwards to the right so as to keep wiring connected
but allowing sufcient room to work.
Slide the bi-fold doors out of the top frame track and set 5.
aside.
Disconnect the log set LED wire harness.6.
Remove the six (6) Philips screws that hold the log set 7.
support bracket in place. Refer to Figure 10 for a side
view of the replace showing screw locations.
!
Some replaces have these three points riveted,
if this is the case, use a 1/8 inch drill bit to drill out the rivet.
Remove the log set and set aside. 8.
Referring to Figure 11, the sides of the log set support 9.
bracket are aligned within the rubber extrusions of the
replace. Slide the bracket directly out the bottom of the
replace and set aside.
Slide Partially reective glass down and out the bottom of 10.
the replace.
Align sides of replacement Partially reective glass with 11.
grooves of rubber extrusions and with brick effect facing
out towards the front of the replace, slide Partially
reective glass up into the replace. The Partially
reective glass should slide into a holding track just
beneath the lter.
Slide Log Set Support Bracket back into place, the sides 12.
of the bracket line up with the grooves of the rubber
extrusions (Figure 11).
Reinstall Log Set while support bracket is loose within 13.
replace. The back edge of the Log Set should t under
the bottom edge of the Partially reective glass, and the
front edge of the Log Set should t in behind the top,
inside edge of the Log Set Support Bracket (Figure 6).
Install Log Set Support Bracket using the six (6) screws 14.
from step 7 (or, if rivets were originally in place, use the
screws supplied with RP kit for Partially reective glass).
Reconnect the LED Wire Harness for the Log Set.15.
Reassemble the bottom panel of the replace following 16.
steps 1-5 in reverse order.
Phillips Head Screwdriver
If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top panel
to cool off to avoid accidental burning of skin.
Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
Remove the rebox from the mantel.1.
Remove the eight (8) Philips screws that fasten the top 2.
cover to the rest of the rebox. There are: three (3)
screws on each side along the top edge; and two (2)
screws on the back along the top edge (Figure 12).
Rear view of replace
Front of
Fireplace
3 Screws to remove (per side)
Steel Curtain, Log Set and Bottom Panel removed for clarity
Partially Reective
Glass
Rubber Extrusions
Log Set
Support
Bracket
These edges of bracket
slide into grooves of
extrusions
To Next Page
Loading...
Need help?
General
