5
temperature setting on the remote will no longer be visible.
!
The heat will not work in manual controls either.
To Enable - Press J and Q at the same time. The
temperature setting will now be visible again.
Depress tab on the battery cover on the back of the 1.
remote control and remove the battery cover (Figure 2).
Move 2. tab to the right to lock the remote
control.
Move 3. tab back to the left to unlock the
remote control.
Replace the battery cover.4.
!
To temporarily unlock the remote control press (in
order) I then J then K.
When the remote control’s backlight is illuminated the
is bypassed. When the backlight is off the
is re-activated.
The remote control has a range of approximately 50 ft.
(15.25m), it does not have to be pointed at the replace
and can pass through most obstacles (including walls). It
is supplied with 243 independent frequencies to prevent
interference with other units.
Depress tab on the battery cover on the back of the 1.
remote control and remove battery cover.
Install 3 AAA batteries into the remote control. (Included)2.
Replace the battery cover.3.
!
The remote control has a battery backup time
of 24 hours. The batteries can be removed for up
to 24 hours before the remote control will require re-
initialization.
!
When the Low Battery icon is present on
the remote control it is recommended to replace the
batteries promptly, to maintain full functionality of the
remote/replace (Figure 4).
Batteries must be recycled or disposed of properly.
Check with your Local Authority or Retailer for
recycling advice in your area.
Plug power cord into 120 volt wall outlet.1.
Turn ON the electrical power at the circuit breaker.2.
Ensure the On/Off switch located inside the replace in 3.
the upper right hand corner is in the ON position.
Set the 3 position manual control to the Remote position 4.
(left position).
Press and hold the initialization button on the unit.5.
While holding the initialization button, press the ame/6.
heat ON/OFF button
or the Purire™ ON/OFF button
on the remote control.
Release the initialization button on the unit.7.
Press the Flame/Heat On/Off button 8.
to turn the
Flame/Heat function ON or press the Purire™ On/Off
button to turn the Purire™ function ON.
If the replace does not respond properly to the remote
control, the remote operating frequency may need to be
reset. The remote control can send another frequency code
to the Remote Control Receiver to eliminate interference.
Press the Flame/Heat On/Off button 1.
to turn the
Flame/Heat ON.
Press the ENTER button on the remote control, the 2.
middle display will ash
.
Use the direction buttons on the remote control to move 3.
the cursor to
and press ENTER.
Press and hold the initialization button on the unit.4.
Press and hold “5.
” left direction button on the
remote
control.
A descending bar graph will appear on the 6.
screen.
The green indicator light will ash on the 7.
unit when the new frequency code has been
stored.
Release “8.
” left direction button on the remote
control.
Release the initialization button on the unit.9.
Press ENTER to return to the main menu.10.
Press the Flame/Heat On/Off button 11.
to
turn the Flame/Heat function ON or press
the Purire™ On/Off button
to turn the
Purire™ function ON.
Right Direction
Button
Down Direction
Button
Sleep Timer
Purifire On/Off Button
Ambient Light Sensor
Occupancy Sensor
Flame/Heat On/Off Button
Left Direction Button
Enter Button
Up Direction Button
Remote Display
Set Temperature
Room Temperature
Time of Day
Low Battery
Indicator
Batteries
To Next Page
Loading...
Need help?
General
