8
Light Bulbs
LED Wire
Harness
Ember
Bed
Side Section
Front
Edge
Log
Ember
Bed
Back
Ledge
Rear
Tab
Upper Light Bracket
Upper Light
Screw
Before programming the heater, use the personal program
schedule below to determine which time and temperature
settings meet your schedule.
Use a pencil to be able to revise your records each time you
are required to change your program settings.
Time Time
To temporarily change the current set temperature without
affecting the current programs:
Press the Flame/Heat On/Off button 1.
- the display
will disappear.
Press the 2.
+ right or left direction button to select the set
temperature.
To cancel the temporary manual override press the 3.
Flame/Heat On/Off button
and the programmed
settings will be reactivated.
The Individual Day setting allows the user to program
the heater thermostat to operate at a select time and
temperature for each day of the week individually.
(
)
Press the ENTER button - the middle display 1.
will
ash.
Use the direction buttons on the remote control to move 2.
the cursor to
.
Press and hold ENTER for 4 – 5 seconds. 3.
display will
ash.
Press the 4.
+ right or left direction button to select the
day of the week. (
)
Press the 5.
up direction button and the hour display to
ash.
Press the 6.
+ right or left direction button to select the
hour.
Press the 7.
up direction button and the minute display
will ash.
Press the 8.
+ right or left direction button to select the
minute.
Press the 9.
up direction button and the set temperature
display will ash.
Press the 10.
+ right or left direction button to select the
temperature setting.
Press the 11.
up direction button and the P1 indicator will
change to P2 and the hour display will ash.
Repeat steps 5 – 10 for the P2 setting.12.
Press the 13.
up direction button and the individual day
programmed will ash.
Press the 14.
+ right direction button for each additional
required program day.
Repeat steps 5 – 14 for the remaining individual days.15.
Press ENTER.16.
Press the 17.
up direction button to turn the
programmable heater function ON and press the
down direction button to turn the programmable heater
function OFF.
Press ENTER to return to the main menu.18.
!
When programmable heater function is ON the
red indicator light is illuminated on the rebox and the
display will appear on the remote control.
!
Press the ENTER button at any time to exit and
return to the main menu.
To Next Page
Loading...
Need help?
General
