DINA SAFEONE DN3PD2 - Page 12

2 Safety
SAFEONE DN3PD2 Manual 7
► Ensure that the output contacts have sufficient protective circuitry for capacitive and in-
ductive loads.
► Follow the specifications in the general technical data.
Note
More detailed information can be found in the → Technical data section.
WARNING
Electric shock – dangerous voltage! During operation, switching devices conduct
dangerous voltages.
Never remove protective covers from electrical switching devices during operation.
► Replace the device the first time a fault occurs.
► Dispose of the device in accordance with nationally applicable environmen-
tal regulations.
2.5.1 Retrofitting and conversion
 Unauthorized conversion voids any warranty. This can cause hazards that can lead to
severe or even fatal injury.
2.5.2 Basic safety regulations
The safety regulations listed below must always be complied with. In the event that these safety
regulations are not complied with or the device is used improperly, DINA Elektronik GmbH
accepts no liability for any resulting injury or damage.
 The product described here has been developed to perform safety-related functions as
part of an entire system.
 The entire system is made up of sensors, analysis units, reporting units and safe switch-
off concepts.
 It is the responsibility of the manufacturer of a system or machine to validate the correct
overall function.
 The manufacturer of the system is obligated to check and document the efficacy of the
implemented safety concept within the entire system. This documentation must be pro-
duced again every time the safety concept or safety parameters are modified.
 The manufacturer's specifications for the system or machine with regard to maintenance
intervals must be complied with.
 DINA Elektronik GmbH is not able to make any guarantees regarding the properties of
an overall system not designed by the company.