C-1 Axle box lubricate oil -
Check
1 Set the vehicle in the parking position.
Make sure no one approaches the work
area.
2 Remove level cap 1. The oil must flow out
through the opening.
3 If necessary, remove filler cap 2. Add oil
to the correct level. Close level cap 1, and
then filler cap 2. Clean the axle surfaces.
Note: check it every 10 hours firstly.
C-2 Wheel reduction gears oil -
Check
1 Set the vehicle in the parking position.
Turn the reduction gear cap in the
horizontal position 2.
2 Remove the cap. The oil level is correct
when the oil flows out through the filler
hole.
3 If necessary, top up with oil (photo) 2 to
the correct level.
4 Refit the cap.
5 Repeat this operation for each wheel.
Note: check it every 10 hours firstly.
To Next Page
Loading...
