42
© 2008 Directed Electronics. All rights reserved.
To access another feature in the same menu:
Press and release the Valet/Program switch the number of times necessary 1.
to advance from the feature you just programmed to the next one you want
to program.
Then press the Valet/Program switch once more and hold it. 2.
For example, if you just programmed the third feature in the menu and you want
to program the seventh feature in the menu, press and release the Valet/Program
switch four times and then press it once more and hold it. The LED flashes and
the horn honks seven times to confirm access to the seventh feature.
To select another menu:
Press and hold the Valet/Program switch.1.
After three seconds, the unit will advance to the next menu, the LED flashes
and the horn honks, indicating which menu has been accessed.
If you just programmed features in the first menu and you want to program a
feature in the third menu, press and hold the Valet/Program switch. After three
seconds the LED flashes and the horn honks twice indicating access to the sec-
ond menu. Continue to hold the button and three seconds later the LED flashes
and the horn honks three times indicating access to the third menu.
Features in the third menu are then programmable following steps 4 through 6
of the System Features Learn Routine procedure.
The learn routine will be exited if any of the following occurs:
The ignition is turned On•
There is no activity for 30 seconds•
The Valet/Program switch is pressed too many times•
To Next Page
Loading...
Need help?
General
