1122
© 2005 Directed Electronics—all rights reserved
pprriimmaarryy hhaarrnneessss ((HH11)),, 99--ppiinn ccoonnnneeccttoorr
This wire sends a negative pulse every time the remote start is activated or the doors are unlocked. This can be
used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to
the disarm wire as shown in the following diagrams.
RReellaayy ffoorr NNeeggaattiivvee ((--)) DDiissaarrmm WWiirree RReellaayy ffoorr PPoossiittiivvee ((++)) DDiissaarrmm WWiirree
This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be
used to pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the
arm wire.
AAss aann aadddd--oonn ttoo aann aafftteerr mma
arrkkeett sseeccuurriittyy ssyysstteemm::
If connected, disconnect the ignition/accessory input of the
remote controlled security or keyless entry system. Connect the H1/3 YELLOW ignition output to the
ignition/accessory input of the remote controlled security or keyless entry system. The wire will prevent the host
system from sensing that the ignition is on during remote start operation.
HH11//33 YYEELLLLOOWW ((++)) iiggnniittiioonn oouuttppuutt ttoo RRFF ssyysstteemm
HH11//22 GGRREEEENN//WWHHIITTEE ffaaccttoorryy rreeaarrmm
HH11//11 LLIIGGHHTT GGRREEEENN//BBLLAACCKK ((--)) ffaaccttoorryy sseeccuurriittyy ddiissaarrmm
To Next Page
Loading...
Need help?
General
