Directed 3305 - Parking Light Jumper

To Next Page

To Previous Page

BLUE and GREEN (-) Multiplex Sensor Trigger Input: These wires are

multiplex sensor trigger inputs. If a (-) input of less than 0.8 seconds is

supplied to either wire, a Warn Away response occurs. A (-) input of

longer than 0.8 seconds to either wire initiates the triggered sequence

and report Zone 4.

Parking Light Jumper

This jumper is used to determine the parking light output polarity. In the

(+) position, the on-board relay is enabled and the unit outputs (+)12V

on the White wire of the primary 12-pin harness. In the (-) position, the

onboard relay is disabled. The White wire supplies a 200 mA (-) output

suitable for driving factory parking light relays.

Note: For parking light circuits that draw 10 amps or more, the jumper

must be switched to a (-) parking light output. P/N 8617 or a standard

automotive SPDT relay must be used on the parking light output wire of

the primary 12-pin harness.

PARKING LIGHT

Important: DO NOT connect the parking light wire of the primary 12-pin

harness to a negative vehicle parking light wire before changing the pro-

gramming jumper to the negative polarity position or damage to vehicle light

circuit may occur.