33
© 2019 Directed. All rights reserved.
Troubleshooting: Security
Starter Disable doesn’t work.
• Is the correct starter wire being interrupted? If the car starts when
the starter disable relay is completely disconnected, the wrong
starter wire has been cut and interrupted.
• Yellow wire is not connected to true ignition. It is connected to an
accessory circuit.
Shock sensor doesn’t trigger the alarm.
• Has the NPC system been triggered? If so, you will hear five chirps
when disarming. To check this, turn the ignition key on and off to clear
the NPC from memory, and then retest the shock sensor. For a detailed
description of NPC (see Owner’s Guide).
Door input does not immediately trigger full alarm. Instead, I hear
chirps for the first three seconds.
• That’s how the Progressive Two-Stage Door Input works! This is the
instant response feature of this system. Even if the door is closed
immediately, the system provides an instant trigger by chirping,
and then progressing to a constant siren.
Closing the door triggers the system, but opening the door does not.
• Have you correctly identified the type of door switch system? This
happens often when the wrong type of door input has been used.
System will not passively arm until it is remotely armed and then dis-
armed.
• Are the door inputs connected? Is a Blue wire connected to the
door trigger wire in the vehicle? Either the Green or the Violet wire
of the primary 12-pin harness should be used instead.
To Next Page
Loading...