Directed 3305 - Pairing a Remote Control

To Next Page

To Previous Page

Pairing a Remote Control

The system comes with two remote controls already paired to the sys-

tem. The control module can store up to four different remote control

codes in memory.

If the system was previously programmed using XKLOADER3, the Learn

Routine may be locked. If the siren generates one long chirp when at-

tempting to program the unit, the Learn Routine is locked and must be

unlocked using XKLOADER3 before proceeding.

1. Open a door. The Green wire or the Violet wire of the primary

12-pin harness must be connected.

2. Turn the ignition on. The Yellow wire of the primary 12-pin har-

ness must be connected.

3. Select a channel. Press and release the Control Center button the

number of times necessary to access the channel you want, and

then press and hold the Control Center button once more. The

siren chirps and the LED blinks the number of times corresponding

to the channel accessed.

Channel/ Function

Channel

Function Wire Color

1 Arm/Disarm

2 Panic Only

3 Silent mode, Remote Valet,

Trunk Release

Red/White

4 Remote starter or other accessories White/Blue