Directed 3305 - Page 30

To Next Page

To Previous Page

Channel/ Function

5 Arm Only

6 Disarm Only

7 Auto learn standard 4- bttn conﬁgu-

ration*

8 Auto learn 3-bttn conﬁguration*

9 Delete all transmitters

Note: For auto learn conﬁgurations, see "Remote Control Conﬁgura-

tions" on page 28 of this guide.

4. While holding the Control Center button, press the button on the

remote control you want to assign to the selected channel. The unit

chirps indicating successful programming.

Note: It is not possible to teach a remote control button to the

system more than once.

Channels 2, 5, 6: Use Channels 2, 5, and 6 to assign the arm, disarm

and panic functions to buttons on the remote control. Teaching a but-

ton to Channel 5 or Channel 1 erases some memory information, and

auxiliary functions may have to be reprogrammed.

Channel 9: If a button from a taught remote is programmed to Channel

9, all remote controls will be erased from memory and system features

revert to the default settings.

This is useful when a customer’s remote is lost or stolen. All remote

controls are erased from the system’s memory. You can also start from

scratch, if the remote buttons are programmed incorrectly.