Directed 3305 - Multi-Level Security Arming

31
© 2019 Directed. All rights reserved.
Long Term Event History
The system stores the last two full triggers in memory. These are not eras-
able. Each time the unit sees a full trigger, the older of the two triggers
in memory will be replaced by the new trigger.
To access long term event history:
1. With the ignition off, press and hold the Control Center button.
2. Turn on the ignition.
3. Release the Control Center button.
4. Press and release the Control Center button again within five sec-
onds. The LED will flash in groups indicating the last two zones
that triggered the unit. The LED will flash for one minute or until the
ignition is turned off.
Note: Warning Zone triggers are not stored to memory and will not
be reported.
Multi-Level Security Arming
Multi-Level Security arming allows the operator to select which inputs
and sensors are active during a particular arming cycle. For a full de-
scription of Multi-Level Security Arming operation for testing purposes
refer to the Owner’s Guide.
Note: This feature is not available with the optional three-button remote
control.