24
© 2019 Directed. All rights reserved.
ignition is turned on/off.
4. Timed (30 seconds): When the command for Channel 3 is
received, the system will output a (-) for 30 seconds (program-
mable for up to 90 seconds in 1 second increments with
XKLOADER3).
5. Factory Alarm Disarm (FAD)
The output will pulse when disarming and activating the
Trunk Release feature for RF Security. Connect to a wire that
will disarm the factory alarm when pulsed to ground.
6. Factory Alarm Trigger (FAT)
The output will pulse when the sensor full trigger zone is acti-
vated. Connect to a wire that will trigger the factory alarm
system when grounded (Usually a door or trunk switch).
7. Second Unlock Output: The output will operate as a 2nd Un-
lock and will only activate when pressing the "unlock" button
on the remote a second time (within five seconds of disarm-
ing). This feature is used when drivers door priority unlocking
is desired.
2-11 Comfort Closure: The system can be programmed to close the
windows when the system is armed 800ms after the door lock output
pulses (or 2nd pulse for double pulses) - the output turns on again for
20 seconds. The Comfort Closure output will be cancelled if the
button is pressed.
To Next Page
Loading...