Directed 5906 - Pairing: LED 2-way or 1-way Remote Control

27
© 2016 Directed. All rights reserved.
5. With both the remote and system in pairing mode, press the button on the remote.
6. The siren chirps to indicate the system has learned the remote ID and is sending its ID to the 2-way
remote.
7. Pair: The LCD remote control will indicate a
Successful
or
Failed
pairing. If pairing fails, the
remote will go back to the
Pair
screen, press the button on the remote again to attempt another
pairing.
8. Once the pairing is completed turn OFF the ignition in the vehicle, the siren will sound to confirm
exiting. Now test the remote for functionality.
To exit Pairing Mode on the remote:
• Wait 30 seconds without pressing a button on the remote.
• Press and release the
button on the remote.
To exit Pairing Mode on the system:
• Turn OFF the ignition.
• Close the open door.
• Wait 60 seconds for the system to automatically exit.
• The siren will sound to confirm exiting.
LED 2-way or 1-way Remote Control:
1. Press and hold the button on the remote for 8 seconds. The transmit LED on the remote will come
ON solid, release the button.
2. Press and hold the button on the remote until the transmit LED flashes 3 times then comes ON
solid. The remote is now ready to pair with the system.
Vehicle Setup for Pairing:
• Open at least 1 vehicle door.
• Turn ON the vehicles ignition to the run position.
• Within 5 seconds press and release the Control Center button on the Control Center one time then
press it once more and hold it.
• The Control Center LED will begins flashing in a single flash pattern and the siren will chirp once to
confirm the system is in pairing mode. You may now release the Control Center Button.
3. With both the remote and system in pairing mode, press the button on the remote. The siren chirps
to indicate the system has learned the remote ID and is sending its ID to the 2-way remote (the 2-way
remote will emit several tones to indicate the remote has learned the system ID, the 1-way remote does
not OFFer confirmations).
4. If pairing fails, press the button on the remote again to attempt another pairing.
5. Once the pairing is completed turn OFF the ignition in the vehicle, the siren will sound to confirm
exiting. When both the system and remote have exited the Pairing mode, test for functionality.
To exit Pairing Mode on the remote:
• Wait 30 seconds without pressing a button on the remote.
• Press and release the
button on the remote.
To exit Pairing Mode on the system:
• Turn OFF the ignition.
• Close the open door.
• Wait 60 seconds for the system to automatically exit.
• The siren will sound to confirm exiting.