Dish Network 196812 - Page 68

Chapter 9
58
Operating Other Devices
Setting Auto-Tune for DVD/VCR
You can set Auto-Tune for your DVD/VCR. Auto-Tune allows you to return to the channel
for your DVD/VCR output when you accidentally change the channel or video input.
1 Make sure the remote control operates your DVD/VCR.
2 Press and hold DVD for three seconds until all four Mode buttons are lit.
3 Press STAR (*).
4 Enter the channel used for viewing (up to three digits in range of 002 to 125), for example
channel “003” or “004.”
5 Press POUND (#). The Mode button flashes three times to indicate programming was
successful.
Removing Auto-Tune for DVD/VCR
If you want to remove Auto-Tune for your DVD/VCR, follow these steps.
1 Press and hold DVD until it stays lit.
2 Press STAR (*).
3 Enter 00 or 000.
4 Press POUND (#).