Dish Network 196812 - Page 75

Receiver Customization
65
Operating Other Devices
To Use a Tuner or Amplifier’s Volume Control
Note: You must first program the tuner or amplifier into the AUX mode of the remote
control to use these steps.
1 Press and hold the AUX button until all the mode buttons are lit, then let it go.
2 Press the POUND (#) button.
3 Press the PLUS side of the VOLUME button.
4 Press 0.
5 Press POUND (#). The AUX button flashes three times.
To confirm the VOLUME buttons are operating the tuner/amplifier’s volume control, press
SAT and then try adjusting the volume. Your tuner/amplifier’s volume should change
rather than your TV’s volume.
To Use the TV’s Volume Control
1 Press and hold the TV button until all the mode buttons are lit, then let it go.
2 Press the POUND (#) button.
3 Press the PLUS side of the VOLUME button.
4 Press 0.
5 Press POUND (#). The TV button flashes three times.
To confirm the VOLUME buttons are operating the TV’s volume control, press SAT and
then try adjusting the volume. The TV’s volume should change.
1
2
3
4
5
6
Press and hold the
AUX Mode button for
four seconds
(button will flash)
Press
POUND
Press the plus
side of VOLUME
Press
ZERO
Press
POUND
(AUX button
will flash 3 times)
Press
SAT Mode
Test to make
sure volume
works on device
1
2
3
4
5
6
Press and hold the
TV Mode button for
four seconds
(button will flash)
Press
POUND
Press the plus
side of VOLUME
Press
ZERO
Press
POUND
(TV button
will flash 3 times)
Press
SAT Mode
Test to make
sure volume
works on the TV