Vender Cash Accounting:
BILLS & COIN IN COIN PAID OUT CASH OUT MANUALLY
Recent Hist. Recent Hist. Recent Hist.
7.50 159.75 3.50 19.50 0.00 0.75
COIN TO BOX COIN TO TUBES BILLS IN
4.75 43.50 .75 8.25 2.00 108.00
Sold Out Activity:
Selection DATE TIME SELECTS ATTEMPTED
1 Cola 9-24-93 1:32pm 13
2 Cola 9-25-93 1:23pm 12
3 Cola ======= ======= =============
4 Apple Juice ======= ======= =============
5 Diet Cola ======= ======= =============
6 Diet Cola 9-26-93 11:30am 5
7 Tea ======= ======= =============
PROGRAMMING THE SIID VENDER
To program the SIID Vender, it is necessary to enter the System Set-Up/Audit/Diagnostics Mode. Open the inner door
and press the Service Switch on the control board. The display reads "ErOr". If the display reads 1.00 the door switch did
not go to its center position or the switch is defective.
Note: The door switch has three positions. Fully in and fully out puts the vender in its normal mode. When the switch
is in its center position the System Set-Up/Audit/Diagnostics Mode may be entered.
There is a time out for the service Mode. If no accounting or set-up functions are used for 2 minutes, the vender will
return to its normal mode. After time out, the service switch on the control board has to be pressed to re-enter the
System Set-Up/Audit Mode.
SIID CONTROLLER PROGRAMMING
0773-6201CS & HIGHER
The controller has two modes of operation:
NORMAL MODE:
In normal mode, the display will show a decimal point. If decimal is blinking, this indicates an error or problem recognized
in the vender. When money is inserted, the display indicates the total amount of the deposit. The select buttons are
used to select the product.
SYSTEM SET-UP/AUDIT/DIAGNOSTICS MODE:
System set-up/audit/diagnostics mode is entered when the vender inner door is open and the service switch is pressed.
The display will show a list of error codes for errors that have occurred since the door was last opened. "JC-#" is a
jammed column, "SS-#" is a select switch problem, and "EN-#" is an
enable error (board component failure).To acknowledge an error,
press any select button, at this time you will enter the menu. The display
will show "HD" at this time. Some of the menu items have sub-menus.
To move through the menus and sub-menus follow these instructions. To:
In-Line
To Next Page
Loading...
