"SE-" - Select Switch Test
Press any select button, and the display will indicate the number of the select button pressed.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"SP-" - Sold Out Paddle Test
Use this to test the sold-out switches if the vender is empty. The display will reflect any Sold
Out Paddles that are pressed, indicating that a column is full. The display will automatically
scroll through the columns in which the sold-out paddles are pressed.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"SW-" - Sold Out Switch Test
Use this to test the sold-out switches if the vender is full. The display will reflect any Sold Out
Switches that are pressed, indicating that the column is empty. The display will scroll through
the columns that are sold out.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"MT-1" - Motor Test
Use this test to run any motor in the stack. Use the following select buttons to run this test.
Select Button 1: Press until desired motor # to run is shown on the display.
Select Button 2: Press to run the selected motor. The display will show "TESTING" and the
selected motor will run.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"CM" - Coin Mech Test
Use this test to check coin mech programming, coin chute work, and coin mech payout
systems.
Insert coins. The value of coins will be reflected on display.
Press & hold Select Button 1: Displays the Coin Mechanism setting.
"MM" - Micro Mech interface
"Lt" - L-Plus interface
"MDB" - Multi Drop Bus interface
Press & hold Select Button 2: Returns the coins inserted.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"NA" - Note Acceptor Test
Use this test to check acceptor functions.
Insert note. The value of note will be reflected on display.
Press & hold Select Button 1: Displays the Note Acceptor setting. ("LL" - low level, "HL" -
high level or "MDB" - multi-drop note acceptor)
Press & hold Select Button 2: Stacks the note and cancels the credit shown on display.
Press & hold Select Button 3: Returns the note and cancels the credit shown on display.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"DSP" - Display Test
Press any select button and the display segments will illuminate in a scrolling manner, while
blinking the exact change LED.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"VERS" - Version of Software
Press any select button and the display will scroll the software revision level in the control box.
Example: ###.## represents the installed software revision.
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
"VNDR" - Vender Identification
Press any select button and the display will show the vender type, that the software has
determined, based on the select panel harness input. The vender types are:
"00" - Coke Venders
"01" - Pepsi and Generic Venders
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
RTN - RETURN TO MAIN MENU
Press & hold select buttons 1 & 2 simultaneously to return to "SE- ".
Press & hold select button 1 to return to "DIAG".
Press & hold select buttons 1 & 2 simultaneously to move to the next item on the menu.
To Next Page
Loading...
