The normally closed contact of the Sold Out Switch has no function. The normally open contact of the Sold Out
Switch is in the Sold Out Circuit (kept open by a can or bottle). When not kept open by a can or bottle, the
normally open contact closes and completes the Sold Out Message Circuit via the SIID Controller Board.
VEND MOTOR
The Vend Motor (one for each vending stack) is mounted on a bracket at the front of the Front Mechanism Plate.
The Vend Motor is in the Vend Motor Coil Circuit. The Vend Motor runs when a normally closed contact of the Select
Switch pushed, opens and signals the SIID Controller Board to run the Motor.
The Vend Motor continues to run via the SIID Controller Board while the Vend Motor Switch is on high side of Cam. The
Vend Motor stops when the Vend Motor Switch Arm drops off the high side of the Vend Motor Cam, and the normally
closed contact of the Vend Motor Switch closes signaling the SIID Controller Board to stop power to the Vend Motor Coil
Circuit.
VEND MOTOR SWITCH
All Columns
A. VEND MOTOR SWITCH
The Vend Motor Switch, one (1) for each circuit, is located on the Vend Motor Assembly and secured by two (2)
screws.
The normally closed contact of the Vend Motor Switch is in the Vend Motor Coil Circuit. This normally closed
contact opens in the Vend Motor Coil Circuit to keep the Vend Motor running, via the SIID Controller Board, until
the Arm of the Vend Motor Switch drops in the Cam notch and the Vend Motor stops.
The normally open contact of the Vend Motor Switch has no function.
VEND MOTOR WIDE COLUMN
Mounted on the Vender with the Vend Switch on the left side (See Fig. 3). The Linkage and Drive Arm assembly
is used to connect the Vend Motor to the Oscillator. (See Fig. 4)
Vend Motor Switch
804,100,730.01
Nyliner (Rear Stack)
801,803,170.01
Oscillator Assembly Nyliner (Front Stack)
491,070,900.03 - 1¼" 901,804,230.01
To Next Page
Loading...
