dji Matrice 100 - Page 14

14
©
2015 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
2. Connect the Aircraft Status Indicator cable to the 6-pin port.
3. Connect the power cable of the ight controller to the 4-pin port.
4. Connect the signal cable of the ight controller to the 6-pin port.
5. Connect the CAN cable on the lower plate to the CAN1 port.
The 6-Pin port with a yellow sticker is reserved. Do NOT connect any cables to this port.
Pull the above cables through the opening behind the battery cover, towards the nose of
the aircraft, before connecting them.
Aircraft Status Indicator
Cable Port (6-pin)
Port for the Flight Controller
Signal Cable (6-pin)
CAN1 Port (5-pin)
Port for the Flight Controller
Power Cable (4-pin)
XT60 Port
Power Cable of the Battery
6. Pull the battery’s power cable through the hole on the battery cover, and then connect it to the
XT60 port on the center frame.
7. Close the battery cover and tighten the screw.