dji Matrice 100 - Gimbal Installation (Optional)

20
©
2015 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
3. Ensure you have followed the previous steps to install the propellers onto their corresponding
mounting plates securely. To ensure the propellers are properly secured, hold the motor in place
with one hand and use your other hand to rotate the propeller in the unlock direction without
pressing down. If the propeller can be removed this way, the propeller and/or the mounting plate
may have become worn and need to be replaced.
Press down on the propellers rmly, and then rotate it in the unlock direction
to detach it from the
motor.
Mounting the Gimbal (Optional)
The M100 is only compatible with the DJI Zenmuse X3 Gimbal with Camera. Do NOT use
other gimbals.
Mounting the Gimbal Lock and Connecting the Cables
1. Remove the two screws (M3x8 self-tapping) on the Aircraft Status Indicator, and then remove the
indicator gently to avoid damaging the cables.
Aircraft Status Indicator