dji Matrice 100 - Page 21

©
2015 DJI. All Rights Reserved.
21
DJI MATRICE 100 User Manual
2. Remove the 16 screws (M2.5x5) on the upper plate of the center frame, and the eight screws
(M2.5x8) on the mounting rails. Then remove the mounting rails and the upper plate.
3. Connect one end of the 10-pin gimbal cable and 8-pin gimbal cable to the ight controller.
M2.5x5
M2.5x8
Flight Controller
10-pin Port
8-pin Port
4. Arrange the other ends of the gimbal cables near the nose of the aircraft.
Aircraft’s Nose