dji Matrice 100 - Page 22

22
©
2015 DJI. All Rights Reserved.
DJI MATRICE 100 User Manual
5. Re-mount the upper plate of the center frame, and tighten the 16 screws (M2.5x5). Orientate the
upper plate so that the notch faces the left of the aircraft (with its tail facing you). Then place the
mounting rails and tighten the 8 screws (M2.5x8).
6. Re-mount the Aircraft Status Indicator, and tighten the two screws (M3x8 self-tapping). Do not
overtighten the screws to avoid damaging the threads.
7. Mount the gimbal mounting plate and dampers to the center frame.
8. Connect the other ends of the 10-pin gimbal cable and 8-pin gimbal cable to the corresponding
ports on the Gimbal Lock.
9. Place the gimbal cable cover on the gimbal mounting plate. Attach the Gimbal Lock under the
gimbal mounting plate. Then tighten the four Phillips screws.
8-pin Port
10-pin Port
Gimbal Lock
Phillips Screws
Gimbal Cable Cover
Gimbal Mounting Plate
Gimbal Lock
The dampers may deteriorate over time. Ensure that all dampers are in good condition before
every ight. Do NOT use worn or broken dampers.