dji Matrice 100 - Battery Installation, Power Management, and Temperature Notes

©
2015 DJI. All Rights Reserved.
25
DJI MATRICE 100 User Manual
Using the Battery
Installing the Battery
Insert the Intelligent Flight Battery into the battery compartment as shown below.
Powering On/Off the Battery
LED1
LED2
LED3
LED4
Power Button (Built-in LED)
Powering On: Press the Power Button once, then press again and hold for 2 seconds to power on.
The Power LED will turn red and the Battery Level Indicators will display the current battery level.
Powering Off: Press the Power Button once, then press again and hold for 2 seconds to power off.
Low Temperature Notice:
1. Using the Intelligent Flight Battery at core temperatures below -10℃ is not advised. Between -10℃
and 5℃, the Intelligent Flight Battery should attain a voltage of 4.2 V, but it is recommended that
you apply the insulation sticker to the battery to prevent a rapid drop in temperature.
2. In cold environments (i.e. air temperature below 5℃), the performance of the Intelligent Flight
Battery is reduced. Ensure the Intelligent Flight Battery is fully charged and attains a voltage of 4.35
V before takeoff.
Never insert the Intelligent Flight Battery into or remove it from the battery compartment of the
M100 when it is powered on.