dji Matrice 100 - PC Assistant Software Usage; PC Assistant Installation, Basic Features, and API Control

©
2015 DJI. All Rights Reserved.
49
Using the PC Assistant
1. Download the DJI Driver and the DJI N1 Assistant installation les from the M100 download page.
2. Complete the installations for the DJI Driver and the DJI N1 Assistant.
(https://dev.dji.com/products/ying-platforms/matrice-100/downloads)
3. Turn on the remote controller, and then turn on the Intelligent Flight Battery in the aircraft. Connect the
M100 to the PC with a Micro-USB cable. Do not disconnect the cable until conguration is nished.
4. Run the DJI N1 Assistant software. Login with your DJI account, or create a new account. Observe
the indicators at the bottom of the screen. When a connection is established, the Connection Status
Indicator (on the left) will glow solid green and the Data Exchange Indicator (on the right) will blink blue.
Basic Page
1) API
If you are using the DJI SDK, select Enable API Control to allow the flight control system to
communicate with external devices such as an on-board computer. The external device will be able
to control the aircraft only if the Flight Mode Switch on the remote controller is toggled to F-Mode. For
information on setting the API parameters, read the related documents and manuals on the DJI SDK
page of the DJI Developer website (https://dev.dji.com/products/sdk).