dji Matrice 100 - Reserved Ports Description

©
2015 DJI. All Rights Reserved.
17
DJI MATRICE 100 User Manual
3. Mount the CAN HUB of the GPS module onto the upper or lower plate of the center frame.
4. Connect the GPS cable to the GPS CAN port on the center frame.
Use the extension rod to separate the GPS module from the center frame power board to
avoid interference.
Use glue to install the GPS extension rod. Ensure it is rm and stable before every ight.
Reserved Ports Description
There are ve types of ports on the center frame. Connect your own devices to them accordingly.
Connect your own devices in strict accordance with the specications of the reserved ports.
XT30 Ports and XT60 Ports
There are three XT30 ports and one XT60 port reserved on the center frame. You can supply power to
your own devices by connecting them to these ports. Use the XT30-XT60 cable if necessary. Identify
the positive and negative terminals of each port before connecting your device.
GPS CAN Port
(Reserved)
[1] XT30 Port [2] XT60 Port [3] GPS CAN Port [4] CAN-Bus Port [5] UART Port
CAN HUB
GPS CAN Port
[1] [2] [3] [4] [5]
[1]
[5] [4]
[1]