dji MATRICE 200 series

70
©
2018 DJI All Rights Reserved.
MATRICE 200 Series User Manual
3. Hold the aircraft vertically, with the nose pointing downward, and rotate it 360 degrees around
the center axis. Re-calibrate the aircraft if the aircraft status indicators blink red.
If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move
your aircraft to a different location and try again.
DO NOT calibrate the compass near metal objects such as a metal bridge, cars, scaffolding.
If the aircraft status indicators are blinking red and yellow alternately after placing the aircraft
on the ground, the compass has detected magnetic interference. Please change your
location.
Auto Takeoff and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to
use the auto takeoff feature:
1. Launch the DJI GO 4 app and tap GO FLY to enter Camera View.
$PNQMFUFBMMTUFQTPOUIFQSFnJHIUDIFDLMJTU
3. Tap“
wBOEDPOmSNUIBUDPOEJUJPOTBSFTBGFGPSnJHIU4MJEFUIFJDPOUPDPOmSNBOEUBLFPGG
4. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision System for stabilization.
The aircraft will automatically hover below 10 meters. It is recommended to wait until there
JTTVGmDJFOU(14MPDLCFGPSFVTJOHUIF"VUP5BLFPGGGFBUVSF
Auto-Landing
Use auto-landing only if the Aircraft Status Indicator is blinking green. Follow the steps below to use
the auto-landing feature:
1. Tap
UPFOTVSFUIBUMBOEJOHDPOEJUJPOTBSFJEFBM4MJEFUPDPOmSN
2. Abort landing process immediately by tapping
on the screen.