DJI Mavic 3 Classic User Manual
52
©
2022 DJI All Rights Reserved.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a combo.
Otherwise, follow the steps below to link the remote controller and the aircraft after activation.
1. Power on the aircraft and the remote controller.
2. Launch DJI Fly.
3. Go to the camera view and tap
> Control, and then Pair to Aircraft (Link).
4. Press and hold the power button on the aircraft for more than four seconds. The aircraft will
beep once when it is ready to link. After linking is successful, the aircraft will beep twice and
the battery level LEDs of the remote controller will glow solid.
• Make sure the remote controller is within 0.5 m of the aircraft during the linking.
• The remote controller will automatically unlink from an aircraft if a new remote
controller is linked to the same aircraft.
• Turn off Bluetooth and Wi-Fi of the remote controller for optimal video transmission.
• Fully charge the remote controller before each flight. The remote controller sounds an
alert when the battery level is low.
• If the remote controller is powered on and not in use for five minutes, an alert will
sound. After six minutes, the remote controller automatically powers off. Move the
control sticks or press any button to cancel the alert.
• Fully charge the battery at least once every three months to maintain the battery
health.
Operating the Touchscreen
Home
To Next Page
Loading...
Need help?
General
