DJI Mavic 3 Classic User Manual
74
©
2022 DJI All Rights Reserved.
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both
sticks simultaneously.
Stopping the Motors
There are two methods to stop the motors.
Method 1: When the aircraft has landed, push and hold the left stick down. The motors will stop
after one second.
Method 2: When the aircraft has landed, perform the same CSC that was used to start the
motors. The motors will stop after two seconds. Release both sticks once the motors have
stopped.
• If the motor is started unexpected, use CSC to stop motors immediately.
Stopping the Motors Mid-Flight
Stopping motors mid-flight will cause the aircraft to crash. The motors should only be stopped
mid-flight in an emergency situation such as if a collision has occurred or if the aircraft is out
of control and is ascending or descending quickly, rolling in the air, or if a motor has stalled.
To stop the motors mid-flight use the same CSC that was used to start the motors. The default
setting can be changed in DJI Fly.
OR
Method 1 Method 2
OR
To Next Page
Loading...
Need help?
General
